Sunday, 18 September 2011

Sissy Bar….Fab Part 1

Range of Steel bought to do the job largest is 2" stock, for bosses & rest will be used for seat bungs etc.
Mark centre heat bend around bolt for correct radius, heat and adjust.
Checking height, angle, and spacing.
Coming out to check on the action.

Turing down the inner fender nuts, from a bolt.

Facing head down to 5mm so not to rub tyres.
These were drilled out & tapped, then parted off to correct size.

Final assortment of parts made for the assembly.

No comments:

Post a Comment