 |
| Myford goodies, Pratt 4-Jaw independant chuck, Myford Swivel Vertical slide, Myford faceplate. Not sure what the little gears are for. The have a 20 marked on them, the sleeve goes in side them and fits the keyway. Then there is a ring with a locking grub screw. These bits and the Myford name plates were a little surprise :-) If anyone knows what they are for be great if you can leave a comment below. |
 |
| Here are all the raw weleded joints. |
 |
| Started cleaning them up with a file. There were a few low points so I decided rather than keep removing metal i would fill with epoxy metal putty and then sand back hopefully less work and a nicer finish. I didn't want to remove too much weld, and weaken the joints. Will have to wait for the putty to cure and get back to it tomorrow. |
This blog always create some informational and amazing things, which add in my knowledge and experience.But I am a bit confuse.A Thanks for sharing.Waiting for next post.
ReplyDelete